I'm troublshooting a 4 axis TB6560 setup.
I am running a code that is 50 concentric circles that have an increasing diameter of 2 mm.
When running the gcode, the y axis dropping a step in each circle, which i can see as the motors turn, and there is a flat spot created in the circles.
Shouldn't dropped steps offset the zeroed home position after a code run? Machine always comes back to the correct 0,0,0 position after several code runs.
I am running a code that is 50 concentric circles that have an increasing diameter of 2 mm.
When running the gcode, the y axis dropping a step in each circle, which i can see as the motors turn, and there is a flat spot created in the circles.
Shouldn't dropped steps offset the zeroed home position after a code run? Machine always comes back to the correct 0,0,0 position after several code runs.