Hi everyone,
I am totally newbie in electronics so I would apprecite some help from experienced ones.
I connected my stepper motors nema17, two of them to Ramps 1.4 board. Uploaded Sprinter to Arduino board and then turned on Pronterface.
When I click on 0,1 step, motor is just whistle, on 1 step it turns only once per two clicks (sometimes), on 10 it turns but randomly, sometimes left, sometimes right. Motors trough spinning vibrate, is it normal ?
I merged voltages on steppers drivers and its around 0,7, I tried to rise it up and down, but it was the same.
My nema 17 is 8wired, so I merged it with ressistance and found pairs, from these pairs I picked one wire and connected to one from oposite pairs, the second one with second one from oposite pairs till I have 4 wires.
As I said my motors now vibrating, spining random direction, whistling.
Any idea what I do wrong ?
Thanks
I am totally newbie in electronics so I would apprecite some help from experienced ones.
I connected my stepper motors nema17, two of them to Ramps 1.4 board. Uploaded Sprinter to Arduino board and then turned on Pronterface.
When I click on 0,1 step, motor is just whistle, on 1 step it turns only once per two clicks (sometimes), on 10 it turns but randomly, sometimes left, sometimes right. Motors trough spinning vibrate, is it normal ?
I merged voltages on steppers drivers and its around 0,7, I tried to rise it up and down, but it was the same.
My nema 17 is 8wired, so I merged it with ressistance and found pairs, from these pairs I picked one wire and connected to one from oposite pairs, the second one with second one from oposite pairs till I have 4 wires.
As I said my motors now vibrating, spining random direction, whistling.
Any idea what I do wrong ?
Thanks