Hello everyone,
as the title of this topic states I'm having some troubles with getting my stepper motors working. I've wired up everything to RAMPS 1.4 according to [reprap.org], uploaded a test firmware [reprap.org] , which should test all 5 motors plus hot end and heat bed.
Well, I haven't plugged the heated bed yet, still 3 out of 5 motors don't move. Specifically the 2 Z axis and the X axis. I really can't figure out where is the problem.
Any help will be greatly appreciated!
as the title of this topic states I'm having some troubles with getting my stepper motors working. I've wired up everything to RAMPS 1.4 according to [reprap.org], uploaded a test firmware [reprap.org] , which should test all 5 motors plus hot end and heat bed.
Well, I haven't plugged the heated bed yet, still 3 out of 5 motors don't move. Specifically the 2 Z axis and the X axis. I really can't figure out where is the problem.
Any help will be greatly appreciated!