when I move my z axis up and down rapidly the whole system resets. The bed-leveling servo jitters wildly when moving any axis, but its plenty worse on the Z.
Ive replaced the ramps, removed stepper drivers, removed the 5v jumper for servos, nothing seems to work.
The power in at the end of the ramps begins to fluctuate and drops to 3v right before the reset occurs. Is it time for a new power supply? what else could it be?
edit the voltage at the end of the ramps doesn't always drop
My setup:
mendelmax 1.5+
Ramps 1.4/arduino mega/4 plololu stepper drivers
heated bed
runs solely off its own 35 watt psu(not entirely sure about the wattage)
no plugins to any computers, just a screen that plugs into the ramps.
this thread is very similar to what i have going on but, found no solution there: [forums.reprap.org]
Ive replaced the ramps, removed stepper drivers, removed the 5v jumper for servos, nothing seems to work.
The power in at the end of the ramps begins to fluctuate and drops to 3v right before the reset occurs. Is it time for a new power supply? what else could it be?
edit the voltage at the end of the ramps doesn't always drop
My setup:
mendelmax 1.5+
Ramps 1.4/arduino mega/4 plololu stepper drivers
heated bed
runs solely off its own 35 watt psu(not entirely sure about the wattage)
no plugins to any computers, just a screen that plugs into the ramps.
this thread is very similar to what i have going on but, found no solution there: [forums.reprap.org]