I am starting a large CNC build and I have a general Stepper motor question.
I bought 3 Nema 23 steppers with the following specifications.
12V, 0.68A, 30mH, 200 steps a Rev
On my test rig I am running the motors at 19V and I'm only getting around 2 revs per second.
If my calculations are correct I should be technically able to drive these at 173V
1000 * SQRT(0.030) = 173 Volts
Since I only need around 10 revs per second would it make sense to drive this motor at 90V? Is it going to overheat or skip steps?
I bought 3 Nema 23 steppers with the following specifications.
12V, 0.68A, 30mH, 200 steps a Rev
On my test rig I am running the motors at 19V and I'm only getting around 2 revs per second.
If my calculations are correct I should be technically able to drive these at 173V
1000 * SQRT(0.030) = 173 Volts
Since I only need around 10 revs per second would it make sense to drive this motor at 90V? Is it going to overheat or skip steps?