Hi, I'm building a metre high delta with a working diameter of 220mm.
I plan to use the Rumba board with DRV8825 drivers, which I already have a stock of, I also plan to have a heated bed which I might run at 24 volts.
My question is what stepper motors should I use in this setup? I'm looking for good detail and will be adding multiple filaments (3) into one extruder plus a separate one for support material when required.
Hope you can help
Thanks
Roger
Fully paid up member of the Old Pharts Club
I plan to use the Rumba board with DRV8825 drivers, which I already have a stock of, I also plan to have a heated bed which I might run at 24 volts.
My question is what stepper motors should I use in this setup? I'm looking for good detail and will be adding multiple filaments (3) into one extruder plus a separate one for support material when required.
Hope you can help
Thanks
Roger
Fully paid up member of the Old Pharts Club
