Hi every one.
I am in search of some stepper motors for my project, and I have a few in mind. However, I encountered these motors, and can not quite figure out whether they are workable (I can not really find anybody online, who have used them). I will initially use a RAMPS with A4988 drivers for my printer. Will they work with my controller?
ACT Motor GmbH 17HS5412-3
Step Angle 1,8°
Rated Voltage 4,16 V
Rated Current 1.3 A
Phase Resistance 3.2 Ohm/Phase
Phase inducturance 5.5 mH/Phase
Holding Torque 5200 g-cm
Detent Torque 2.8 N.cm Max
Rotor Torque 68 g- cm²
Lead Wires 4
Shaft Diameter 5,0 mm
Motor Length 48 mm
Motor Weight 0,36 kg
Alternatively, I'm going to use 17HS19-1684S1 (1.68A, 45Ncm)
/Hans
I am in search of some stepper motors for my project, and I have a few in mind. However, I encountered these motors, and can not quite figure out whether they are workable (I can not really find anybody online, who have used them). I will initially use a RAMPS with A4988 drivers for my printer. Will they work with my controller?
ACT Motor GmbH 17HS5412-3
Step Angle 1,8°
Rated Voltage 4,16 V
Rated Current 1.3 A
Phase Resistance 3.2 Ohm/Phase
Phase inducturance 5.5 mH/Phase
Holding Torque 5200 g-cm
Detent Torque 2.8 N.cm Max
Rotor Torque 68 g- cm²
Lead Wires 4
Shaft Diameter 5,0 mm
Motor Length 48 mm
Motor Weight 0,36 kg
Alternatively, I'm going to use 17HS19-1684S1 (1.68A, 45Ncm)
/Hans