Quantcast
Channel: Reprap Forum - Stepper Motors, Servo Motors, DC Motors
Viewing all articles
Browse latest Browse all 549

extruder working but not XYZ (1 reply)

$
0
0
Hello. I recently completed putting together a prusa i3 with RAMPS 1.4. I loaded it with the reprap test code found at (http://reprap.org/wiki/File:RAMPS1.4_TestCode.pde) everything works fine and all the motors move back and forth some. When I load it with Marlin firmware I am only able to make the extruder motor move. XYZ do not move and simply make noise. I am using Pronterface to run test commands. Any help would be appreciated and please assume I am stupid. Thank you

Viewing all articles
Browse latest Browse all 549

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>