Hi everyone
I'm new to the forum and 3d printing in general.
I am planning on building (trying to) a reprap prusa i3 using spares I can salvage. I work a lot with big, floor standing printers so I have access to some fun parts to play with.
One question I have at this moment is whether the stepper motors in there will work for the project.
Here's the specs I can see on the motor:
6 wires coming out of it
Shinano Kenshi Co. LTD. China
Part number is B2381715B (can't seem to find references on google)
STP-42D2058-05
23Z86G stamped on the sticker
1.8 degree step, 2.8 ohm
I'm new to the forum and 3d printing in general.
I am planning on building (trying to) a reprap prusa i3 using spares I can salvage. I work a lot with big, floor standing printers so I have access to some fun parts to play with.
One question I have at this moment is whether the stepper motors in there will work for the project.
Here's the specs I can see on the motor:
6 wires coming out of it
Shinano Kenshi Co. LTD. China
Part number is B2381715B (can't seem to find references on google)
STP-42D2058-05
23Z86G stamped on the sticker
1.8 degree step, 2.8 ohm
